These are used switches, pulled from games that were parted out over 20 years ago.
They have been in heated storage.
This is the entire pop bumper switch with mount, and spoon.
The switch blades measure 1-3/8″ from the front of the wafer stack to tip.
To the best of my knowledge this was used on solid state pins only!
This switch will also fit early Stern SS pops, but the mount is shorter in height.
Most will still have diode and/or capacitor attached, but, maybe not all.
Patina on metal may vary.
Bally Switch: ASW-A110-5
Mount Bracket: AS-982-1130
Bally Assembly: AS-2911-1