Coin Box Gottlieb System-1, & Star 80 Powder Coated With Lid

$49.99 CAD

Out of stock

Description

If your refurbishing, or have refurbished your pinball, then this is a great addition; as it adds that final touch.

I have only one left in stock, is shows a few creases and tiny dents, when the light hits it just so. (See Gallery)

These have been sandblasted, and powder coated with a metallic silver/grey.

This fits the System 1 & Star 80 series pins.

This model comes complete with the removable lift out lid.

It also has the smaller length handle, that measures 4-3/8″ long.

Photo shows it in a Haunted House pin.

The photo gallery has a few photos that will show the differences between the two versions of this Gottlieb Coin Box.

Note the differences, as the dimensional sizing is the same!

–One has rolled edges on the left and right ends to accommodate a lid that slides forward to removal.(For EM’S)

–The handle measures 4-1/4″ long on this unit offered here, and 6″ long on the other.(for EM’S)

–The handle on this unit sits much lower, starting 3/4″ from the bottom, compared to the EM version which starts at 1-5/8″ from the bottom edge.

I offer a refinished coin box for the EM version as well.

NOTE: If you try to put a EM version in a System-1 or Star 80 Series pin, it will fit, but you won’t be able to close the coin door, as the handle sits too high.

BUT, either version will fit into a EM.

THEY MEASURE 11″ WIDE, 8-1/4 DEEP (9-1/8″ INCLUDING HANDLE), 4-3/4″ TALL AT THE BACK, & 3-7/8″ TALL AT THE FRONT.

Additional information

Weight 1.6 kg
Dimensions 29 × 24 × 13 cm

Inquiry

If you have any questions about any of our products, don’t hesitate to reach out! You can also give us a call at 1-306-955-6636.